- Tuo AI
- Live
- My Account
- Shopping Cart
- Inquiry Basket
- Contact Us
- Back to Top
Process Library
Cold roll forming process workflows
Corrugated / Arc Roof Sheet Forming
The bend angle is part of the build: the hydraulic shear cuts and bends in one station, with the angle set in the PLC.…
Ceiling Cross Tee / Secondary Runner
Fixed length + flat silhouette—avoid borrowing main-runner punch kits.
C/U Open-Close Stud Line
Two mating profiles that slide/interlock—show dimple choice, outfeed direction, and pack.
C/U Stud Forming with Punch & Dimple
C and U profiles share the same side-dimple pattern; the C profile adds two punch layouts plus a stamped ST logo.
Curving / Crimping (Arch)
The curving unit takes an already-formed panel and puts a controlled radius into it, so a straight roof or wall sheet…
Cut-to-Length Leveling Line (3×1250)
Coil car → hydraulic decoiler → 4-hi leveler → loop pit → side guide → servo straighten/feed → cross shear → conveyor →…
C/U/Z Purlin Auto-Change Forming
C, U and Z share one auto-width line — the U profile runs with anti-drift locators so all three stay accurate.
Diamond / Rhombus Tube Forming
If the board could be swapped for a round lockform tube, the distinction is unclear.