Can One Shutter Slat Machine Run Two Profiles?

1. Short answer

Yes — when the proposal includes it. Recommended shutter-slat packages can run two profiles by swapping a full roll set on one host. It is not a free default on every single-profile machine. After changeover, verify cutter, optional punch dies, and PLC recipe.

2. How dual profile works

• Full roll-set exchange on a shared frame (documented on the recommended English slat package)
• Market cassette tooling — swap a pre-built cassette bank for faster changeover (industry practice)
• Re-check length recipe and optional punch map for the second profile
• Trial run before production — do not assume first-profile settings remain valid

3. Reference parameters (context only)

Do not assume CS-104 numbers apply unchanged to a European thin profile on the same host without re-rating.

4. Conflicts and open items

• Dual profile vs PU + single on one line — PU adds foam stages; that is a different configuration family.
• Borrowing thickness across profiles — Each profile keeps its tier (CS / single / European / PU).
• “Two profiles” without tooling list — Not orderable until roll sets / cassettes are named.

5. Boundaries (related machines)

• Frame opening changeover — Spacer + cutter on a frame host; different procedure.
• Guide section change — Separate SHUTTER family.
• Double-layer roof hosts — Unrelated “two profiles” story from roofing packages.

6. Buyer FAQ

Is dual profile the same as PU + single-layer on one line?

No. PU adds foam/heat/reshape stages. Dual profile means two slat geometries via tooling change.

Is cassette changeover automatic on every quote?

No. Cassette is common market practice; the recommended package wording emphasizes full roll-set swap. Write the method into the proposal.

Do I still need two cutters?

Often yes — match cut-off tooling to each profile. Confirm on the dual-profile tooling list.

Can guides and slats share one dual-profile host?

No. Guides/boxes are a different section family with different power tiers.