Metal Sheet Punching Machine with Cut to Length Production Line From Coil 500

Metal sheet punching machine with cut to length production line from coil 

 

Each part details elements introduction:  

5 Ton hydraulic decoiler
Support the coils and doing uncoiling.
The decoiler expands and shrinks by hydraulic and fit to the inner diameter of coils.
Motor drives the coils running and can do forward and do the decoiling with tension.
The core can ensure the expand range
Structure: welding by the steel plates and profiled bar.
The capacity is 5 Tons (max)
Support material thickness from 0.4 to 1mm
With the loading car:
1. Hydraulic entry coil car
The Min gap between the coil car and the De-coiler front should be 500 MM to avoid any problems during coil loading.
The car can move levelly and vertically, which is convenient for putting the steel coils into the de-coiler.
It is driven vertically by hydraulic cylinder with four guide pillars.
The level movement is driven by cycloid motor.
The capacity of it can reach to 5 Tons (MAX)
It is used to lift up and down, move forward and back to make it easy to load the coils on decoiler. Hydraulic controls lifting, motor drives moving. The car is controlled on the auxiliary control panel. Its moving speed is 6-7m/min.When the coils on decoiler, the car will return back to the start position. It can also carry back the unfinished coils from decoiler.

 

 

 

160 Ton Punching part with molds

LEVELING PART:  Type: model
Servo motor power:1.5kw
Control system: by PLC
For making sure the coil neat and clean
PART :Punching machine             Pressing machine parameters:
Model: 100 Ton 1 unit                 Punching times from 160 times adjustable.
With servo coil feeder:                 With punching molds:
With the oiling system:

 

The Metal sheet perforated machine steel plate punching machine High speed rotary punching machine can be designed with 50 tons, 100 tons, 200 tons, 250 tons and higher tons according to the holes size and sheet width and thickness.Below is the specification of each perforated machine.

 

More standard type For Your Reference:

Nominal Pressure kn 1250 Slider Stroke mm 20 Perforating Speed times/min 120-140 Feeding Width mm ≤1250 Engine Power kw 18KW-4 or as required	JMC-160 Slider Stroke mm 30 Perforating Speed times/min 200 Feeding Width mm ≤1500 Engine Power kw 18.5 or as required
JMC-160 High Speed Slider Stroke mm 30 Perforating Speed times/min 200 Feeding Width mm ≤1500 Engine Power kw 30kw-6 or as required	JF200-G Nominal Pressure kn 2000 Slider Stroke mm 30 Perforating Speed times/min 100-200 Feeding Width mm ≤1500 Engine Power kw 30KW-6 or as required

 Punching for removing corner

With the handrail adjustable for the following width: 450, 600, 650, 800, 850mm.

As to the cut to length function:

Leveling and cutting     Shaft diameter: 90 mm
Machine frame: 350H steel welding
Material of rollers: Inside 45# steel outside Rubber
Drive motor power: 7.5kw                    Processing speed: 0-25m per minute
Leveling rollers: up layer 8 rollers down layer 9 rollers
Transmission way: chain with gear
Voltage: customzie 
Material thickness: 0.3-1.5 mm
Processing material: SS, GI 
Cut power: hydraulic power           Cutting blade material: Cr12
And then you can adjust to how many pieces to slit.
With 2 meter convey table.